19
Connecting the power cable/disconnect device
In this procedure you will connect the power cable and the disconnect device. The disconnect
device is the plug on the power supply cord.
To connect the power cable
1
Make sure the printer’s power switch is turned OFF.
2
Make sure the power of the Heating System and the Roll Take-Up System are turned
OFF.
3
Plug the printer-end of the power cable into the connector at the back of the printer.
4
Connect the cable of the Roll-Take-Up System with the Printer body.
5
Plug the other end of the power cable into an electrical outlet of the correct voltage and
with a proper grounding.
Power supply
Voltage:
200 to 240 VAC or 100 to 120 VAC
Frequency:
50/60 Hz ± 1 Hz
Current:
< 10 A (110 V)
< 5 A (220 V)
Note: When you turn off the power, please note that your printer needs a few seconds to
perform its shut down sequence. After powering OFF, wait for at least five seconds before
switching the printer on again.
Summary of Contents for Jetster
Page 1: ...Gerber Jetster Eco solvent Printer Owner s Guide...
Page 2: ......