Gerber Jetster, Owner'S Manual, Page: 20 / 59

14 CHAPTER 2
Installing and Setting up the Gerber Jetster
To assemble the printer on the stand
CAUTION: At least four people are needed to lift and assemble the printer on the
stand. When taking the main unit out of the carton, remove the plastic wrapping
first and handle the printer directly. There is a risk of your hands slipping if the
main unit is handled through the plastic wrapping.
1
Remove the cardboard sleeve from the box.
2
The main unit must be lifted by four people at the places marked
(1)
to
(8)
in the
following illustration. If it is lifted at other places (left and right side covers, ink
cartridge cover, etc.) you may drop the printer and cause injury or damage.
3
Fix the printer body onto the leg assembly using the two wing
screws. As described in the stand assembly procedure, the end
plates should be mounted as high as possible on the stand legs.
If you need to adjust the end plates, loosen the bolts slightly and
push them upward. Temporarily tighten the endplate screws
with the 3 mm hex key. Then fix both wing screws tightly. Once
the wing screws are fastened, tightly secure the bolts on the
endplates with the hex key.