Gerber DCS 1500, Getting Started Manual

Page: 26 / 176

Page 18
E
ngl
is
h
Figure 8: Control box
ID Component

Pen tool pressure regulator – Used to regulate the pen
tool pressure and tool holder 3 pressure.

Tool holder 1 pressure regulator – Knob that controls
the air pressure to the corresponding tool holders.

Tool holder 2 pressure regulator – Knob that controls
the air pressure to the corresponding tool holders.

Status board – Provides information about the cutter’s
operating status.

System energized light – Illuminates when hardware
components are energized.

E-Stop switch – Push when there is danger to people,
the cutter, or the cut material.

AC power switch – Turns cutter power on and off.

Primary reset button – Distributes power to hardware
electrical components. It is also used to reset the
machine.