5. Select the COM port that is connected to GV-DFR1352 and click
Open COM
. The serial
number and firmware version of the reader will be automatically detected. The red square
next to the COM port box should change to blue to indicate the COM port is correct.
6. Under
Master / Slave
, set the reader to
Slave
.
7. Select an
ID Number
for the reader. The ID number ranges from 0 to 7.
8. Click
Setup
. The settings are sent to GV-DFR1352.
If you want to connect multiple readers to the GV-System, you need to set up a unique ID
number for each reader. For this you need to connect each reader to the computer one
reader at a time, and follow the instructions above to set up an ID number.
Note:
1. If the COM port is incorrect, an “
Error opening serial port
”
message will appear. To
verify the COM port that is connected to GV-DFR1352, go to Windows Device
Manager. In the Ports (COM & LPT) field, you should see the entry for
Prolific USB-to-
Serial Comm Port
and the COM number currently in use.
2. If you are using an older version of the GV-Reader Config AP, you will have to
manually type the serial number of GV-DFR1352. The serial number is on the rear
panel of GV-DFR1352.
April 24, 2014
6