34
Detection Target
:
⚫
Human:
Select it and then alarms will be triggered if someone intrudes into the
pre-defined area.
⚫
Motor Vehicle
: Select it and then alarms will be triggered if a vehicle with four or more
wheels (eg. a car, bus or truck) intrudes into the pre-defined area.
⚫
Non-motor Vehicle
: Select it and then alarms will be triggered if a vehicle with two
wheels (eg. a motorcycle or bicycle) intrudes into the pre-defined area.
All of the three types of objects can be selected simultaneously. Please select the detection
objects as needed. If no object/target is selected, alarms will not be triggered even if intrusion
detection is enabled.
2. Set the alarm holding time and alarm trigger options.
3. Set alarm trigger options. The setup steps are the same as motion detection. Please refer
to
4.
Click the “Save” button to save the settings.
5. Set the alarm area of the region entrance detection.
Click the “Area” tab to go to the
interface as shown below.
Set the alarm area number on the right side. Up to 4 alarm areas can be added.
Cli
ck the “Draw Area” button and then click around the area where you want to set as the
alarm area in the image on the left side (the alarm area should be a closed area). Click the
“Stop Draw” button to stop drawing. Click the “Clear” button to delete the alarm area. Click the
“Save” button to save the settings.
6. Set the schedule of the region intrusion detection. The setup steps of the schedule are
the same as schedule recording setup (See
4.1.4.1 Schedule Recording Settings