September 10, 2021
4
4.2 Wall Mount Installation
For wall mount, make sure to prepare 2 screws of 4 mm in length and 5.5 ~ 7 mm in
diameter and prepare 2 screw anchors of matching size.
1. Drill two evenly-leveled holes on the desired wall that are 122 mm apart.
2. Hammer the two self-prepared screw anchors into the holes on the wall.
3. Insert the two-self prepared screws into the screw anchors and tighten to the point where
there are about 1.5 mm left hanging out.
4. Hang the switch onto the screws with all of its ports pointing downward.
4.3 Powering On the Switch
To power on the switch, connect it to a power source using the supplied AC power cord. The
switch will respond as following upon turning on:
The Power LED is lit.
The DATA LED flashes momentarily, signaling system initiation.
Note:
Make sure to leave at least 10 cm of space around the switch for adequate
ventilation.
