September 10, 2021
3
3. Rear Panel
The AC power socket for powering the system is located at the rear panel and accepts power
input from 100 to 240 V at 50/60 Hz.
4. Installation
Prior to installing the PoE switch, please note the following:
Only clean the switch when it is unplugged and with a dry cloth without involving any
liquids.
Do not place the switch near water or any damp area and prevent moisture from
entering the switch chassis.
Do not place the switch on an unstable surface where it may be severely damaged due
to a fall.
Ensure there is proper ventilation at the installation site and keep the ventilation of the
switch free of obstruction.
Make sure the operating voltage is consistent with as labeled on the switch.
Do not open the chassis during operation or when there are electrical hazards in
avoiding electric shocks.
4.1 Leveled Installation
Attach the four supplied rubber feet at the bottom of the switch and place it on a leveled
surface.
Note:
Make sure to leave at least 10 cm of space around the switch for adequate
ventilation.
