17
V1.0 September 2017
5.3 Installation with extension rods
contd
….
8. Remove the red end cap from the end of
the extension rod that is going to be
connected to the lowest sensor.
STEP 8
-
Connect the first extension rod
to the bottom wheel assembly making
sure to check the
‘
pin
-
socket
’
alignment
and tighten the connector until the locking
clip
’
snaps
’
into place.
Carefully lift the assembly up to
vertical and position it over the
inclinometer casing, ready for installation.
Ensure that the installation fork is
available to be used when the first length
is installed.
(Continued from page 16)
(Continued on page 18)
The
‘
fixed
’
wheel
should be located in the keyway
in the direction of the expected
of movement
Direction of movement
