9
16
Assembly Instructions
(Cont.)
15. Insert the Drip Pan into the back of the Grill then insert the Drip Tray into
slots beneath the Drip Pan. See view below.
16. Attach one end of the regulator gas line to the fitting that feeds the Side
Shelf Burner, see Detail A. Attach the other line to the fitting that feeds the
four burners in the Grill, see Detail B. Make sure the fittings are tight. Refer
to the
Leak Test
section in this manual and be sure to follow all the steps.
Connect the Ignitor wire to the Ignitor beneath the burner, as shown in
Detail C,. by simply pushing it on to the crimped end of the Ignitor.
17. Install the AA Battery into the Ignitor. Unthread the Ignitor Button Assembly
on the front of the Control Panel, drop in the battery, negative end down,
then screw on the Ignitor Button Assembly
18. Fasten the Tank Clamp
Bracket (short) to the upper
position and the Tank
Support Bracket to the lower
position by inserting the top
end of each Bracket into the
access slots in the right Side
Panel and securing them in
place with Short Bolts, Lock
Washers and Flat Washers.
19. Hang the 20 pound LP cylin-
der on the Brackets and
connect the regulator to the
tank. Tighten securely by
hand.
Detail A
Tank Clamp
Bracket
Tank Clamp
Support
Detail B
Detail C
Regulator
Drip Pan
Shelf
17. Drip Tray (P/N 22509)
18. Hanging Rack (P/N 22510)
19. Back Panel (P/N 225511)
20. Cruet Shelf (2) (P/N 22513)
21. Side Panel, Left (P/N 22512L)
22. Side Panel, Right (P/N 22512R)
23. Bolt, Long (19) (P/N 22515)
24. Bolt, Short (6) (P/N 22514)
25. Shoulder Bolt (2) (P/N 22520)
26. Nut, Self Locking (2) (P/N 22516)
27. Flat Washer (25) (P/N 22517)
28. Lock Washer (25) (P/N 22518)
29. "AA" Battery
30. Wrench (2) (P/N 22519)
17
18
19
20
21
22
23
24
25
26
27
28
29
30
GR-GBQ440_IB_1-4-04 4/1/04 3:28 PM Page 17