GEONAUTE WATCH CHRONO 700, Manual

Page: 7 / 8

27 26
5 Stopwatch mode
START/STOP : start/stop the stopwatch
RECALL : recall of intermediate times recorded
SPLIT/RESET : to record an intermediate time
MODE : go to the following mode
•
Display :
- Top line : the current value of the stopwatch
- Middle line :
LAP , the time around
- Bottom line : SPLIT , the intermediate time
•
In this mode, the screen will display the letters STW in the middle of the screen when
the stopwatch is functioning.
•
Once the stopwatch has stopped, the word STOP will appear to the left of the screen.
•
The stopwatch enables you to measure intermediate times ( SPLIT , the time passed
since the start up to the given point) and laps ( LAP , the time passed since the last partial
time measurement up to the given point).
It enables you to measure up to 999 intermediate times and to store the first 299
measurements in memory.
•
On the top line, you will read the current stopwatch value (Format - hour : minutes :
seconds : 1/100s). The maximum value is 99 h 59min 59s 99.
•
On the middle line, you will read the lap time value (LAP) (Format - hour : minutes :
seconds, hundredths of seconds).
On the top left of the screen, the three-digit indication of the intermediate time counter will
appear.
•
On the bottom line you will read the value for the intermediate times (SPLIT) .
•
To re-initialize the stopwatch
When the stopwatch has stopped, press the SPLIT/RESET button for 3s to reset to 0.
The stopwatch is started/stopped by pressing the START/STOP button. You can accumulate
several time measurements by pressing START/STOP again between each measurement.
When the stopwatch is going, by pressing repeatedly on the SPLIT/LAP button, you can
display intermediate times and lap times on the corresponding lines. With each press, the
intermediate time counter goes up by one.
Once the number 99 is reached, the counter will flash to signal that the memory is full. Display
of the word
FULL .
When the stopwatch has stopped (START/STOP) , the last lap is put into memory.
•
Using the memory
When using the stopwatch, the first 99 intermediate times and lap times are memorized.
They can be recalled, whether the stopwatch is in action or not, by pressing the
RECALL
button. The order of reading is different depending on whether the stopwatch is
functioning or not.
If the stopwatch is functioning :
By pressing RECALL repeatedly, scroll through the values already put into memory in the
following order :
- The fastest lap time
(FAST)
- The slowest lap time (SLOW)
- The average lap time of the X measurements recorded (AVG)
- The last lap time (x)
- The next to last lap time (x-1)
…
- Le 1er temps au tour
(1)
If the stopwatch is not functioning :
By pressing RECALL repeatedly, scroll through the values already put into memory in the
following order :
- The fastest lap time
(FAST)
- The slowest lap time (SLOW)
- The average lap time of the X measurements recorded (AVG)
- The FIRST lap time (1)
- The SECOND lap time (2)
…
- The next to last lap time
(x-1)
- The last lap time (x)
00:00’:09’’
12
00:00’:19’’
05
[003]
LAP
SPLIT
00:00’:19’’
05
STW
DÉPART 400 m 800 m 1200 m 1500 m
START
LAP 1 LAP 2 LAP 3 LAP 4
SPLIT1
SPLIT 2
SPLIT 3
END : SPLIT 4