Geokon GeoNet 8900 Series, Instruction Manual

Page: 33 / 56

MODEL 8900 SERIES GEONET WIRELESS DATA HOSTING SYSTEM | NETWORK INSTALLATION | 21
When the Status button is pressed on a Node, the current status of the radio
signal will be displayed briefly by the LEDs. The Node will then indicate the
status of the radio signal after each radio transmission for a period of 10-
minutes. If the Node has not yet joined the network, it will change its radio
interval to approximately one second and search for an available network.
8:
TABLE 8: Status Button Functions
Device Function Status Button Action
Supervisor or Node Reset
Press and hold until both LEDs
illuminate (
~ 10 seconds)
Cellular Supervisor &
Mesh Supervisor Put the network into Deployment mode/extend Deployment
mode. Display the current status.
Press and release
Cellular Supervisor Take a reading and send existing data immediately Press and release
Node
Display the current status, then indicate signal strength
every radio cycle for 10 minutes
Press and release