8
| SPLICING PREP | GEOKON
7.
Remove the paper and 25 mm (1 inch) of inner jacket to expose the braided
shield.
8.
Remove the braided shield to expose the two twisted pair wires and shield wire.
9.
Remove the mylar wrapping to expose the 2 pair wire leads and shield wire.
10. Strip the insulation back approximately 12 mm (½ inch) on the red & black
gauge wires and on the green & white thermistor wires.
Note:
Do not connect the fitting nut to the connector adapter until you after you
have finished splicing the wire leads. Refer to Section 2 for more information.
Braided Shield
Inner Jacket
Twisted Pair Wires
Twisted Pair Wires
Shield Wire
Armor
Gauge
Thermistor
Thermistor
Gauge
Shield
Armor
