G408 User Guide Document: G408-2
----------------------------------------------------------------------------------------------------------------------------- -----------------
17
9.5.
Bezel Compensation
➢
Through [Overlap] menu, user can adjust image cropping area and adjust image position.
➢
User can apply test pattern and reduce [Overlap] value to enlarge the image to the bezel center
line between two monitors to achieve bezel compensation.
➢
User can also calculate the pixels number for bezel compensation based on the video wall
dimension and bezel size. If the video wall active display area is 360cm in width and the input
source is 3840, then the pixel number for each centimeter is 3840/360=10.67 pixel/cm. If the bezel
size is 12mm in one edge, then user can decrease Overlap value 10.67*1.2=12.8 (13) pixels to do
bezel compensation for that edge (to enlarge the image 13 pixels at that edge).
➢
User can apply the same method to correct the position mis-alignment in monitor installation or set
image position for irregular video wall.
10. OSD Lock and Unlock
➢
User can hold [MENU] key on front panel or remote controller for 5 seconds to lock OSD to prevent
someone to change the settings. After OSD menu is locked, user will see flashing LED on Power
key on the front panel at 0.5” interval.
➢
User can hole [MENU] again for another 5 seconds to unlock OSD and do further operation.
➢
User can set Box ID for each G408 and control via remote controller:
✓
Press
［
851
］，
all the box OSD will be locked except ID #1 G408. The [INFO] LED will be
lighted in the locked unit and only ID #1 G408 can be operated.
TV4
TV7
TV1
TV5
TV8
TV2
TV6
TV9
TV3
G408
G406s
