ASSEMBLY INSTRUCTIONS
The first step is to attach the Left and Right rail sections to the Mid rail section already
attached to the main press frame. Each side is attached to the Mid rail section by union plates.
Carefully position the left or right rail section to the union plate (already attached) on the Mid
rail section. Adjust the feet on the rail section so the aluminum bars mounted to the inside of the
Mid rail section and the left or right rail section are level.
Attach the lower cross channels on each section and tighten. Make sure that the
adjustable leg locking nut is tightened to prevent movement of the foot. Before tightening all
hardware, make sure of the following:
•
All aluminum bars are level & straight with each other.
•
The center distance between the front and rear aluminum bars are the same on the left, right
& mid rail sections.
•
Lower cross channels are attached.
•
Adjustable feet are locked by tightening the nut on the threaded stud up against the black leg.
Note: All of the hardware needed was shipped either in the hole used for or in a separate
package.
RIGHT RAIL SECTION ATTACHED TO MID RAIL SECTION
UNION
PLATE
MID RAIL
SECTION
RIGHT
RAIL
SECTION
