5. Apply Pressure to Rear Bumper Guard:
Using a rubber roller, starting from the center out, press down the perimeter of part to ensure proper bond of
adhesive (Figure 9). Use caution to ensure roller does not scratch vehicle.
A.
Rubber Roller
Remove die cut templates and tape.
D.
Wipe the Rear Bumper Guard and bumper area to remove any marks or smudges.
B.
Inspect for proper adhesion and placement. Verify the part is not loose at any corner.
C.
06/06/19
SK713
Figure 9
NOTE: Do not wash vehicle through an automatic car wash for at least 24 hours.
Page 13/18
