Programming
Note:
For best results, replace the battery in the hand-held transmitter with a
new
battery before programming.
If your garage door opener receiver (located in the garage) is equipped with an antenna, make sure the
antenna is completely uncoiled and hangs straight down.
1.
Press and hold the two outside buttons - releasing
only
when the indicator light begins to
flash
after 20 seconds
. (This procedure erases the factory set default codes and does not have
to be followed to program additional hand-held transmitters.)
2.
Hold the end of the hand-held transmitter of the device you wish to train approximately
one to three inches away from the HomeLink surface -
keeping the indicator light in view.
(For placement questions, please contact
HomeLink at
1-800-355-3515
or on the internet at
www.homelink.jci.com.
)
3.
Using both hands, simultaneously push the hand-held transmitter button
and
the desired
HomeLink button.
Do not release the buttons until step 4 has been completed.
Note: Some entry gates and garage door openers may require you to
replace
this programming step (#3)
with the procedures noted in the “Canadian Programming / Gate Programming” section.
4. The HomeLink indicator light will flash, first slowly and then rapidly. When
the indicator light flashes rapidly, release both buttons. (The rapid flashing light
indicates s uccessful programming of the new frequency signal.)
If, after 20 seconds, the indicator light does not flash rapidly, release both the HomeLink and the hand-held
transmitter buttons and repeat steps two through four.
However, position the hand-held transmitter at a different
length and/or angle
until the indicator light begins to flash rapidly. Release both buttons after the indicator light
flashes rapidly.
Refer to “Rolling Code Programming” and/or “Canadian Programming/Gate Programming” for additional procedures if
necessary.
To activate the garage door or other programmed device upon successfully completing the steps above, press and
hold the HomeLink button - releasing when the device
begins
to activate.
To program the remaining two buttons, follow steps 2 through 4.
If you do not successfully program the HomeLink Universal Transceiver to learn the signal of the hand-held
transmitter, refer to “Rolling Code Programming” within this text
or call toll-free for customer assistance at
1-800-
355-3515
or on the internet at
www.homelink.jci.com.
