17
www.gentecaustralia.com.au
WALL MOUNTED ELECTRONIC SENSOR PLATE
STS3500
Wall bracket installation
All fixtures must be installed using slim
compression fittings.
1.
Allow a straight line cut 190mm (width)
x 120mm (height) in the wall 70mm to
110mm deep. Screw the bracket (1) to
the wall and tighten.
Do not compress
or distort the bracket.
2.
Connect the sensor cable from the
sensor plate (2) to the solenoid wire.
Use
a conduit to feed the wire up to the
sensor plate.
3.
Install the sensor plate by tightening the
screws provided (3) equally. The screws
have up to 10mm adjustment.
Important information
Plug in the power adaptor
first and test electronics
before turning on the water
supply.
*Regular service must be carried out on the product to avoid product failure.
