SYSTEM TURN ON: After completing all wiring and signal
connections you can now turn the system on.
ADJUST: Raise volume of the unit to maximum. Adjust left and right input gains
of the unit until half way between minimum and maximum. Gradually increase
source volume until clip. Begin gradually increasing input gains until distortion is
audible, then reduce slightly, System should be extremely load at this point. Turn
the volume control down to minimum and back up to comfortable level.
Volume changes should sound linear and balanced.
NOTES: Set your source volume at one -half to three quarter up and leave it.
Always use your volume as a master(main) volume control. It has better
electronics, higher S/N ratio and is more linear than any source unit volume
available. If engine noise is audible, try raising the volume on the source unit,
and/or check the ground connection on the unit.
ELECTRICAL INSTALLATION
One of the best features of this unit is that it allows the listener to adjust each band
exactly to his own satisfaction, so please note that the correct settings depend
very much on the overall system itself and the individual musical taste of the
listener. Please check the settings for each band carefully before completing the
installation.
CROSSOVER CONTROL
+12V
REM
GND
SUBWOOFER
SPEAKER
REAR
SPEAKER
AMP
FRONT
SPEAKER
RADIO/CASSETTE
CD CHANGER
-5-
-6-
Summary of Contents for G-EQ5B
Page 1: ......
