5
2.4. Sandpaper
The specification of sandpaper ranges from # 40 to # 200. Also
note that the maximum operating speed which the sandpaper can
afford shall be higher than the rotation speed of this tool.
2.5. Protections
The approved eye protector, ear-muff, mouth-muffle, and gloves
shall be worn when operate this tool.
2.6. Working Place
The working place shall be ventilated.
2.7. Energy supply failure
Release the on-off device in case of energy supply failure.
3. Operation, Adjusting And Replacing Method
3.1. On-off device
The on-off device is on the top of this tool. It is a “hold-to-run”
type. You can alsoadjusting the running speed by raising or
lowering the lever. This tool stops rotation within a few seconds,
after releasing the lever. For the sake of safety, put it on a soft
cloth or on hanger after it completely stops.
3.2. Sand pad
If the sanding pad is no longer adhesive, you should change to a
new one. To change it, turn up the shroud and insert the supplied
wrench to fix the screw bolt in the central then turn the pad as
shown in the ilustration below. Fix the wrench on this screw nut.
4. Maintenance
4.1. Lubrication
Before connecting the hose, apply 4 or 5 drops of #60 spindle
oil at the air inlet. The use of a thicker oil can lead to reduced
performance or malfunction. If a thicker oil is used by accident,
wash it away immediately. Also, every 3 or 4 hours of operation,
oiling is necessary.
4.2. Storage
Avoid storing the tool in a location subject to high humidity. If the
tool is left as it is used , the residual moisture inside the tool can
cause rust. Before storing and after operation, oil the tool at the
air inlet with spindle oil and run it for a short time.
4.3. Disposal
If the tool is too damaged to be used anymore, drop it in a
resource recycling can. Never drop it into fire.
4.4. Ordering service Parts
For further operational and handling information or for
replacement of parts and components, contact the sale agent
from whom you purchased the tool or the service division of our
company.
User Manual
EN
Screw
Shroud
Pad
Tight
Loose
Dust Collector
Air hose
