Genie Z-45J, Operator'S Manual

Page: 44 / 74

Operator's Manual
Fifth Edition • First Printing
Inspections
42 Z
®
-
45J DC • Z
®
-45J Bi-Energy Part No. 1297032GT
Test Limited Drive Speed
36 Press down the foot switch.
37 Raise the primary boom approximately 3 feet /
91 cm.
38 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the primary boom raised should not
exceed 1 ft / 30 cm per second.
39 Lower the primary boom to the stowed
position.
40 Raise the secondary boom approximately
3 feet / 91 cm.
41 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the secondary boom raised should not
exceed 1 ft / 30 cm per second.
42 Lower the secondary boom to the stowed
position.
43 Extend the primary boom approximately
2 feet/61 cm.
44 Slowly move the drive control handle to the full
drive position.
Result: The maximum achievable drive speed
with the primary boom extended should not
exceed 1 ft/30 cm per second.
45 Retract the boom.
If the drive speed with the primary or
secondary boom raised or the primary boom
extended exceeds 1 ft/30 cm per second,
immediately tag and remove the machine from
service.
Test Drive Tilt Cutout
46 Press down the foot switch.
47 With the boom fully stowed, drive the machine
onto a slope where the chassis pitch angle is
greater than 2.5°.
Result: The machine should continue to drive.
48 Return to level ground and raise the primary
boom to an out of stowed position
(approximately 10° above horizontal).
Result: The machine should stop once the
machine reaches 2.5° of chassis tilt and the
alarm should sound at the platform controls.
49 Lower the primary boom to the stowed
position.
Result: The machine should drive.
50 Return to level ground and extend the primary
boom approximately 1.6 ft / 0.5 m.
51 Drive the machine onto a slope where the
chassis pitch angle is greater than 2.5°.
Result: The machine should stop once the
machine reaches 2.5° of chassis tilt and the
alarm should sound at the platform controls.
52 Retract the primary boom to the stowed
position.
Result: The machine should drive.