Operator's Manual
Second Edition • Second Printing
26
Genie TMZ-50/30
Part No. 114255
Emergency Stop
Push in the red Emergency Stop button to the off
position to stop all ground and platform control
functions.
Repair any function that operates from the ground
or platform controls when the Emergency Stop
button at the ground controls is pushed in.
Repair any function that operates from the
platform when the Emergency Stop button at the
platform controls is pushed in.
Set up
1 Position the machine directly below the desired
work area.
2 Set the parking brake.
3 Disconnect the trailer lights, chains and surge
brake safety cable from the vehicle.
4 Open the latch on the ball coupler.
5 Pull the jack release handle and rotate the
tongue jack to the lifting position.
6 Raise the tongue by turning the jack handle.
7 Open all boom hold-down latches.
8 Push and hold the auto-level button. Push and
hold the extend outrigger button. The
outriggers will lower and adjust to level the
machine and raise the wheels slightly off the
ground.
9 Be sure that all four interlock display lights are
on at the ground control panel.
Operating Instructions
Do Not Operate Unless:
You learn and practice the principles of safe
machine operation contained in this operator's
manual.
1 Avoid hazardous situations.
2 Always perform a pre-operation
inspection.
3 Always perform function tests prior to use.
4 Inspect the workplace.
5 Only use the machine as it was intended.
Fundamentals
The Operating Instructions section provides
instructions for each aspect of machine operation.
It is the operator's responsibility to follow all the
safety rules and instructions in the operator's,
safety and responsibilities manuals.
Using the machine for anything other than lifting
personnel and tools to an aerial work site is unsafe
and dangerous.
Only trained and authorized personnel should be
permitted to operate a machine. If more than one
operator is expected to use a machine at different
times in the same work shift, they must all be
qualified operators and are all expected to follow
all safety rules and instructions in the operator's,
safety and responsibilities manuals. That means
every new operator should perform a pre-
operation inspection, function tests, and a
workplace inspection before using the machine.
800-610-4101
ActionRental.com
