Genie S-40 TRAX, Service And Repair Manual

Page: 117 / 159

July 2019 Service and Repair Manual
Deutz D 2.9 L4 Engine Fault Codes
Part No. 1286829GT S- 40 XC • S - 45 XC • S - 40 TraX • S-45 TraX 107
SPN = Suspect Parameter Number
FMI = Failure Mode Identifier
KWP = Keyword Protocol
SPN FMI KWP Description
1188 7 1415 Wastegate actuator; blocked
1188 11 1411 Wastegate actuator; internal
error
1188 11 1412 Wastegate actuator; EOL
calibration not performed
correctly
1188 11 1416 Wastegate actuator; over
temperature (> 145øC)
1188 11 1417 Wastegate actuator; over
temperature (> 135øC)
1188 11 1418 Wastegate actuator; operating
voltage error
1188 13 1413 Wastegate actuator calibration
deviation too large, recalibration
required
1231 14 85 CAN-Bus 1 "BusOff-Status"
1235 14 86 CAN-Bus 2 "BusOff-Status"
1237 2 747 Override switch; plausibility error
1322 12 610 Too many recognized misfires in
more than one cylinder
1323 12 604 Too many recognized misfires in
cylinder 1 (in firing order)
1324 12 605 Too many recognized misfires in
cylinder 2 (in firing order)
1325 12 606 Too many recognized misfires in
cylinder 3 (in firing order)
1326 12 607 Too many recognized misfires in
cylinder 4 (in firing order)
2659 0 1524 Physical range check high for
EGR exhaust gas mass flow
2659 1 1525 Physical range check low for
EGR exhaust gas mass flow
2659 2 1523 Exhaust gas recirculation AGS
sensor; plausibility error
SPN FMI KWP Description
2659 2 1527 AGS sensor temperature
exhaust gas mass flow;
plausibility error
2659 12 1526 Exhaust gas recirculation; AGS
sensor has "burn off" not
performed
2797 4 1337 Injector diagnostics; timeout error
of short circuit to ground
measurement cyl. Bank 0
2798 4 1338 Injector diagnostics; timeout error
of short circuit to ground
measurement cyl. Bank 1
2798 4 1339 Injector diagnostics; short circuit
to ground monitoring Test in Cyl.
Bank 0
2798 4 1340 Injector diagnostics; short circuit
to ground monitoring Test in Cyl.
Bank 1
3224 2 127 DLC Error of
CAN-Receive-Frame AT1IG1
NOX Sensor (SCR-system
upstream cat; DPF-system
downstream cat); length of frame
incorrect
3224 9 128 Timeout Error of
CAN-Receive-Frame AT1IG1;
NOX sensor upstream
3248 4 1047 Sensor error particle filter
downstream temperature; signal
range check low
3699 2 1616 DPF differential pressure sensor
and a further sensor or actuator
CRT system defective
3699 2 1617 Temperature sensor us. and ds.
DOC simultaneously defect
3699 14 1615 Maximum stand-still-duration
reached; oil exchange required
4765 0 1039 Physical range check high for
exhaust gas temperature
upstream (DOC)
4765 1 1042 Physical range check low for
exhaust gas temperature
upstream (DOC)