Geniewatch, NSD5451 User Manual (Ver. 1.0)
Genie Network
15
2.2
Installation using Surface Mount Bracket
①
To pass cables through to upside of ceiling,
make a hole whose diameter is about
50~60mm on the ceiling panel.
②
After assembling Rubber Gasket to
Mount Cover, install Mount Cover on
surface of ceiling panel.
③
Hook up “Drop Prevention Spring” on main
body to prevent camera from unexpected
drop and connect cables to Main Body with
terminal blocks.
④
Check the 2 mold line for assembly
before starting assembly. Line up the
mold lines as shown in the circle shown
below and assemble Main Body to
Mount Cover. Then screw up the 4
screws with wrench included in the
product box and detach the vinyl on
dome cover
### Important Notice ###
•
Before starting installation, make sure that Camera ID and Protocol are set up properly.
•
When the pipe hole on side of Mount Bracket is not used, make sure that the hole is closed
properly.
Wrench
