Genie CCTV KB5451, User Manual

Page: 6 / 8

6
LCD displays: TRACK: 01 SUM: 001
B. Press [ TELE ] :
LCD displays: [ No:001 Point:001 ]
Enter one of the preset points of the group ranging from No. 1~128
C. Press [ TELE ] : Set up the moving speed
LCD displays: [ No:001 Speed:001 ]
The speed represents the moving speed between two preset points and is divided into 1-8
phase. (1: fastest speed; 8: slowest speed)
D. Press [ TELE ] : Set up the retention time
LCD displays: [ NO:001 TIME:001 ]
The displayed time is the retention time of each preset point and can be set from 1 to 99
seconds.
E. Press the [ TELE ] key to go back to step B to set up next point. Press [ OFF ] to end and
save your setting.
4.9 Start Preset Point Group Scanning (Do not apply to PELCO Protocol)
Enter: SHOT + N + ENTER
LCD displays: SHOT NO : XXX
XXX: No. 1~4 preset points group scanning.
4.10 Horizontal Revolution of 2 Preset Points ( Do not apply to PELCO Protocol )
Description: This function is designed to set the speed dome at horizontal revolution in a
small zone.
Enter: Press [AUTO].
LCD displays: 1ST NO: 000
Enter a start point for Auto Pan scanning. The start point should be one of the preset points.
Complete preset point setting first by following Step 4.5.
Press the [ON] key to complete the start point setting.
LCD displays: 2ND NO : 000
Enter a stop point for Auto Pan scanning. The stop point should be one of the preset points.
Complete preset point setting first by following Step 4.5.