2. LAMP BODY INSTALLATION
Notes: Do not install it nearby the curtain or flammable materials. Only for indoor use.
OPERATION
1. SET DIPSWITCHES
■
Each fixture occupies 12 DMX channels.
■
DMX 512 signals can control multi-fixtures together; however you must set DMX address of each lamp first.
Different DMX address will lead to different movements.
■
You can set DMX address from 1~
500
on the multi-function display panel.
■
Switch on power supply and after finishing resetting, the panel will show 001,that is to say DMX address is
001 and the first lamp has been controlled by 1~12 channels.In turn the second fixture has been controlled by
13~24 channels. (When panel shows 001, press
UP/DOWN
button until it shows 013.Then just press
ENTER
button). In the same way, the third fixture has been controlled by 25~36 channels and the panel shows 025.
■
Through this method, you can control multi-fixtures to perform different movements.
2
.
CHANNEL FUNTIONS
No.
DISPLAY
FUNCTION
1
Addr
001-501(503)
DMX address (16BT is on, the max value is 501).
M-DM DMX
mode.
M-AU AUTO
mode.
2 MODE
M-SO SOUND
mode.
3 PRCO
PR-1~PR-8
8 built-in programs.
Pr1-4 means skip.
Pr5-8 means fade.
4
SPCO
SP01~SP15
Auto speed is 0.1~20 seconds each step.
STND
Run clockwise as DMX value increases.
5 rPAN
REV
Run anticlockwise as DMX value decreases.
STND
Run clockwise as DMX data increase.
6 rTILT
REV Run
anticlockwise
as DMX data decreases.
STND
CH7:PAN, CH8:TILE, CH10:PAN FINE, CH11:TILT FINE.
7 r-PT
REV
CH7:TILE, CH8:PAN, CH10:TILT FINE, CH11:PAN FINE.
ALL
Check all LEDs with motors.
PAN
Check pan channels, Display
“
Pan
”
.
TILT
Check TILT channels, Display
“
TITL
”
.
RED
Check red channels, Display
“
rEd
”
.
GREN
Check green channels, Display
“
GrEn
”
.
8 TEST
BLUE
Check blue channels, Display
“
bLuE
”
.
Page 15 of 18
