SRL-6005 PAR LAMP
E. DMX mode enables the use of a universal DMX controller device. Each
fixture requires a "start address" from 1 to 511. A fixture requiring one or more
channels for control begin to read the data on the channel indicated by the
start address.
There are many different types of DMX controllable fixtures and they all may
vary in the total number of channels required. Choosing a start address should
be planned in advance. Channels should never overlap. If they do, this will
result in erratic operation of the fixtures whose starting address is set
incorrectly.
For example ------Each Par Can occupies 7 channels
If the starting address of the first channel of the first fixture is set to 001, so
The first fixture: 001~007
The second fixture: 008~014
The third fixture: 015~021
The forth fixture: 022~028
The fifth fixture: 029~035
……
6. DMX Connection
DMX fixtures are designed to receive data through a serial Daisy Chain. A Daisy
Chain connection is where the DATA OUT of one fixture connects to the DATA IN
of the next fixture. The order in which the fixtures are connected is not important
and has no effect on how a controller communicates to each fixture. Use an order
that provides for the easiest and most direct cabling. Connect fixtures using
shielded two conductor twisted pair cable with three pin XLR male to female
connectors.
The shield connection is pin 1, while pin 2 is Data Negative (S-) and pin 3 is Data
positive (S+).
6. Via Master/Slave, you can set one par lamp to Auto Mode, and others to DMX
Mode. In this way, the master and the slaves run in-sync.
AUTO Mode
When the 10th dipswitch is off, PAR Can system enters into Auto Mode. The system
runs in built-in auto program.
In Auto Mode
Dipswitches: #1, #2, #3, #4, #5, #6, #7, #8, #9
Function: Adjust the Auto-run speed.
6
