DMX Controller
DMX Linking Text
：
Use a 3 pin connector to connect the fixtures according to the above picture, each
fixture setted in the same address(address can be in 001-512), then they can work synchronization with
DMX signal.
IV.
Master Mode
1. Auto mode:
Hold the button “
MENU”
until the mode is changed to the Auto mode, loose you finger, then the working
mode will be changed to the Auto mode automatically. Press “
MENU
” button to choose the different
code. Please see the picture as below, then press “
UP
” or “
DOWN
” button to change the code. If you
hold the button “
UP
” or “
DOWN
” button, the code will be changed rapidly.
S p x
S b x
F d x
P g x
Specification:
Prg XX(1~9):
Choose the internal program, there are 9 internal programs.
Spd XX(1~9):
Choose the speech of the internal program, there are 9 steps, 1 is the slowest and 9 is the
fastest.
Stb XX(0~9):
Choose the frequency of strobe for the internal program.
Fad XX(0~9):
Choose the fade of the internal program, there are 10 steps, 01 is the fastest and 9 is the
slowest.
Note
: If you set up the strobe and fade together, the flash will be in the priority. If the Stb is not 0, Even
Fad is not 0, the fixture will run the strobe not fade program.
2.Manual mode
Hold the button “
MENU”
until the mode is changed to the Manual mode, loose you finger, then the
working mode will be changed to the Manual mode automatically. Press “
MENU
” button to choose the
different code. Please see the picture as below, then press “
UP
” or “
DOWN
” button to change the code.
If you hold the button “
UP
” or “
DOWN
” button, the code will be changed rapidly.
G x x
B x x
R x x
Rxx(00~10):Set the brightness of the red LED.
Gxx(00~10):Set the brightness of the green LED.
Bxx(00~10):Set the brightness of the blue LED.
Page 4 of 5
