Genetec omnicast 4.8 SR3, Configuration Manual

Page: 73 / 101

Panasonic
genetec.com | Omnicast Video Unit Configuration Guide 4.8 SR3 66
EN.100.007-V4.8.C3.(1)
Panasonic
This section describes the additional configuration steps required for some Panasonic units and
unit features to work in Omnicast.
•
"Configuring H.264 software motion detection" on page 66
•
"Configuring multi-streaming in MJPEG" on page 66
•
"Configuring I/O pins" on page 67
•
"Configure capture resolutions" on page 68
•
"Configuring edge analytics for WJ-NT314 units" on page 68
•
"Configuring WV-SC385 (DG-SC385) units" on page 68
•
"Configure WJ-GXE500 (DG-GXE500) units" on page 69
•
"Use auto-pan with Panasonic units" on page 69
Configuring H.264 software motion detection
Software motion detection is based on metadata sent from the camera which is affected by the
Sensitivity setting on the unit’s Web page. For best results, increase the
Sensitivity value on the
unit’s Web page before you configure software motion detection in H.264.
Configuring multi-streaming in MJPEG
Multi-streaming in MJPEG is supported on certain Panasonic cameras in Omnicast. In the
Video Quality tab of Panasonic camera entities in Config Tool, the
Image quality setting must be
the same for both video streams, and can only be configured from stream 1.