Control Valve Installation
1.
Remove the temporary shipping cap. The 32mm
riser will come preinstalled in your tank. The appropriate
amount of resin is factory installed in the tank up to
48,000
grain sizes. 64,000 grain and larger systems may
have been
partially loaded with resin and a media funnel
and
additional instruction provided to add the full
amount of
remaining resin. The actual resin in the tank
may vary due
to shipping conditions but the proper level
will range from
just above 1/2 to 2/3 full in the tank.
2.
Install Valve Base O-ring around the neck of the valve.
3.
Lubricate the center hub O-ring of the
Genesis Upflow
valve.
4.
Install the top basket with a twist and lock action to center
hub of the
Genesis Upflow
valve.
5.
Do not use teflon tape or pipe seal
ant
to attach control
valve to tank.
6. Place
Genesis Upflow
valve onto tank with the distributor pipe
inserted down the middle of the top basket. Rotate
clockwise to secure onto
the tank.
Do not overtighten! Overtightening may cause the valve
to crack and void the warranty.
Figure 5-1
Genesis Upflow
Valves & Systems Service Manual
