11
English
To Change the Blade
1. Unplug the saw
2. Loosen the Phillips screw (1) on the blade bolt cover (2).
3. Lift up the lower blade guard (3) and the blade bolt cover(2)
to expose the blade bolt.
4. Depress the spindle lock button (7) and rotate the blade until
the spindle locks.
5. Using the Allen Wrench (4) provided, loosen the blade bolt (5)
by turning it clockwise. Remove the blade bolt.
6. Remove the outer blade flange (6).
7. Remove the old blade off the saw.
NOTE:
A blade washer may be use for the blade with arbor
hole bigger than 5/8 inch.
8. Mount the new blade carefully onto the spindle, being sure
that the directional arrow on the blade surface matches the
arrow on the upper blade guard.
9. Replace the outer blade flange and the blade bolt.
10. Depress and hold down the spindle lock button while
tightening the blade locking bolt securely with the provided
wrench in a counterclockwise direction.
11. Lower the lower blade guard and the blade bolt cover to its
original position.
12. Retighten the Phillips screw securing the blade bolt cover.
13. Be sure the spindle lock has released and blade rotates freely
before plugging in the tool and making a cut.
LASER GUIDE (FIG 11)
WARNING:
Laser light – do not stare
into the beam, aperture, or into a reflection from a
mirror-like surface.
WARNING:
Avoid exposure – laser light
is emitted from the rear guard aperture. Use
of controls or adjustments, or performance of
procedures other than those specified herein may
result in hazardous laser light exposure.
WARNING:
DO not disassemble the laser
module.
WARNING:
USE of controls or adjustments
or performance of procedures other than those
specified herein may result in hazardous radiation
exposure.
Your miter saw is equipped with a Built-in Laser (1). No battery is
required for laser operation. The laser can be turned on when the
saw is connected to a power source. The Laser ON/OFF switch
(4-FIG 1) is located on the top of the handle.
The laser alignment was made at the factory and is set for the
center of the Blade or Draw line. Adjustment may be required
prior to initial use due to the effects of shipping and handling. You
also have the ability to adjust the line projected by the laser to
your liking. You may wish for the laser to be to right or left of the
blade, or straight on a drawn cut line. Where you ultimately decide
to align the laser in relation to the saw blade’s cutting path will
determine how you align the cut line.
FIG 6
1
2
3
FIG 8
4
FIG 9
6
5
FIG 7
7
FIG 11
2
1
2
