Genesis GLMT12, Operator'S Manual

Page: 11 / 48

11
English
nOTE:
Some accessories, such as a saw blade, may be mounted either
straight on the tool, or at an angle to enhance usability. always make sure the
4 pins are engaged as in step 2 above.
To install the Sanding pad and Sandpaper
1. Loosen and remove the cap screw (1), and the washer (2) from the shaft flange.
2. Place hook & loop sanding pad (5) against the shaft flange(4), making sure to position it with
one tip facing straight forward. Make sure that the 4 pins on the shaft flange fully engage the
sanding pad, and that the pad is flush against the shaft flange. See FIG 3.
3. Put the cap screw and the washer back on. Tighten the cap screw to secure the sanding pad
on shaft flange.
4. Align the sandpaper (6) and press it onto the sanding pad (5) by hand. Turn the tool over, and
firmly press the sandpaper against a flat surface to secure the hook and loop paper. See FIG 3.
nOTE
:
For maximum sandpaper life, rotate the pad or sandpaper 120
degrees when tip of sandpaper becomes worn.
Warning:
DO nOT tighten the cap screw unless the accessory is
properly seated on the shaft flange.
To remove accessories from the tool,
simply just reverse the above procedures.
OPEraTiOn
Warning:
To reduce the risk of serious personal injuries, read and
follow all important safety warning and instructions before using this tool.
Warning:
always disconnect battery pack from tool or place the
switch in the locked or off position before any assembly, adjustments or
changing accessories
.
Switch Action (FIG 4)
To start the oscillating tool
, slide the ON/OFF switch
forward to ON position.
To stop the oscillating tool
, slide the ON/OFF switch
backward to OFF position.
Overload Protection
your tool is equipped with an overload protection circuit to protect the motor and battery in the event
of a stall. When the tool is stalled, it will automatically turn itself off. If this happens, remove the tool
from the work piece, turn off the tool, wait for a few seconds, then turn it on and continue using it.
Sometimes, when the battery is low, the tool may shut down automatically more often. This indicates
it is the time to recharge the battery.
Fig 4
ON
OFF