WWW.WEbER.cOm
®
25
mAINTENANcE
ELECTRONIC IGNITION SYSTEM OPERATIONS
If the Electronic Ignition System fails to ignite, be sure there is gas flow by attempting to
match-light your burners . Refer to “MAIN BURNER MANUAL IGNITION” . If match-lighting
is successful, the problem lies in the electronic ignition .
m
WARNING: All gas controls and supply valves should be in
the OFF position.
• Verify that the AA battery (alkaline only) is in good condition and installed correctly
(1) . Some batteries have a plastic protective wrap around them . This plastic must be
removed . Do not confuse this plastic with the battery label .
• Make sure the ignition wires are attached to igniter module properly. Refer to the
“IGNITER MODULE WIRE GUIDE” below .
• Make sure the ceramic igniter assembly is fully positioned into burner tube igniter
channel
(2) . If properly positioned, you will hear a snap (3) .
• Make sure the Electronic Ignition button is working by listening and looking for sparks
at burner .
If the Electronic Ignition System still fails to light, contact the Customer Service
Representative in your area using the contact information on our web site.
Log onto www.weber.com
®
.
◆
IGNITER mODULE WIRE GUIDE 310
1
2
3
4
1
2
3
4
A
B
C
Wire End & Terminal Colour
Burner Tube
Black
(1)
Left Burner
(A)
Yellow
(2)
Right Burner
(B)
Blue
(3)
Centre Burner
(C)
Green (Earth)
(4)
Centre Burner
(C)
1
2
3
Summary of Contents for GENESIS 310
Page 27: ...www weber com 27 MEMO ...
