Product Features and Applications
Primary Applications
Recommended for commercial and residential softening or demineralization water treatment systems.
•
Softening System Pre-Treatment
•
Iron Removal System
•
Ion Exchange Equipment
•
Boiler Softening Water Treatment
•
RO Pre-Treatment
Product Characteristics
• Mechanical
Components
The Genesis 2 AIO used internal ceramic discs which are corrosion and abrasion resistant to form and hermetic
seal. Rotation of the upper disc aligns to the corresponding lower disc ports for Service, Backwash, Brine & Slow
Brine, Brine Refill and Fast Rinse modes.
• Excellent
Flow
Rate:
Up to 20 gpm @ 15 psi drop
• 365
Day
Usage
Memory
• Manual / Delayed
R
egeneration
Pressing at any time results in an immediate manual regeneration.
Pressing and holding for 3 seconds, when system is locked, results in a delayed regeneration at the
preselected time.
• Extended
Power
Outage
Indicator
If outage exceeds 3 days, the time of day indicator "
" will flash 12:12. The current time of day needs to be
re-set.
All other set parameters remain stored in memory. The valve will resume to operate form the point of
the
power outage.
•
T
hree
Regeneration
Sequences
• Lockout Function
Keypad will lock after 5 minutes without use. To access the parameter changes press and hold and
simultaneously for 3 seconds to unlock.
• LCD Display Screen
• Maximum Day Regeneration Interval
When the valve reaches the maximum programmed service days, without reaching the set service capacity, it
will trigger a regeneration at the pre-programmed time of day. Regeneration(s) reset both the maximum day
regeneration value and the service capacity value.
• One Button to Change the Current Time
Pressing and holding the button for 3 seconds, when system is locked, allows the current time of day to be
adjusted.
• Service Alarm
When the service alarm feature counts-down and reaches set point, (Selectable 30 day min to 900 day max in
30 day increments) the alarm will activate at 8pm. The alarm will sound for 2 minutes and then shut off
automatically. To silence alarm within the 2 minute period, press any button. A service call message will then
appear on the screen as a signal for the homeowner to contact a water treatment professional for routine
service. To eliminate this message from the screen, unlock the valve programming by pressing the UP and
DOWN arrows simultaneously until the padlock in the upper left corner of the screen disappears
(approximately 3 seconds). Next, enter the programming menu by pressing the MENU/CONFIRM button once
and then pressing the BACK/REGENERATION button once. The system will then go back to normal status and
the operational days will re-start new count-down. Note: The system will operate normally when it is displaying
the service alarm message.
4
