GENERALTOUCH TECHNOLOGY CO., LTD
Issued by: Customer Service Department 5
/
22 Issued Date: 2013.10.14
发行部门：客户服务部
发行时间：
2013.10.14
Installation Key Points for GeneralTouch SAW Touch Screen
吉锐声波触摸屏安装要点
First of all, please focus on the following summary of key points concerning assembling the GeneralTouch
SAW touch system. Before, during and after the assembly, please follow each key point below to check
whether the SAW touch screen is assembled correctly or not.
首先，请关注下面关于安装吉锐声波触摸系统的要点总结。在安装前、安装过程中及安装后，请逐一按照下面的
要点核对声波触摸屏是否被正确安装。
1. Disassemble the front frame and the back cover of monitor. The touch screen will be stuck onto the front
surface of the LCD panel, and the controller will be fixed onto the chassis or back cover of the monitor.
拆下显示器的前框和后盖。触摸屏将被粘贴在液晶显示面板前面，控制器将被固定在显示器的铁盘或后盖上。
2. Stick the touch screen onto the metal frame of LCD panel by double-sided
adhesive tapes. Please pay
attention to:
用双面胶将触摸屏粘贴在液晶显示面板的金属边框上。请注意以下事项：
1) Make sure the surface of the metal frame of LCD panel is flat and without any thrust;
请确认液晶显示面板的金属边框表面是平整的，没有任何的突起。
2) Before sticking the touch screen, please clean the surface of the metal frame of LCD panel where the
double-sided adhesive tapes will be stuck;
在粘贴触摸屏前，请清洁液晶显示面板的金属边框表面，双面胶将贴在上面。
3) Before sticking the touch screen, please clean the viewable area of LCD panel and the rear surface of
touch screen;
在粘贴触摸屏前，请清洁液晶显示面板的可视区和触摸屏的背面。
4) Please adjust the location of the touch screen to make sure the viewable area of LCD panel is within
the active area of touch screen, which means the reflection stripes of touch screen should be out of the
viewing area of LCD panel;
请调整触摸屏的位置来保证液晶显示面板的可视区在触摸屏的可触摸区内，这样触摸屏的反射条纹就不
会出现在液晶显示面板的可视区内。
The double-sided adhesive tapes are mainly used to prevent dust and moisture from going into the
clearance between the LCD panel and the touch screen, and help to fix the touch screen before
assembling the front frame. Because the touch screen has gravity, there should be some special
designs on the front frame or alternative frames to support the touch screen after the assembly.
双面胶主要是用来防止灰尘和水汽不会进入液晶显示面板和触摸屏之间的狭缝，并在安装前框前帮助固
定触摸屏。由于触摸屏的自重，因此前框上需要有一些特殊的设计或者有其他边框，在安装后支撑触摸
屏。
