PROBE
Each SEEKER 400 Video Inspection System is supplied already connected to
a one-meter-long flexible-obedient probe. The SEEKER 400 System has a
slim 12-millimeter diameter tip. The SEEKER 400-09 system is supplied with
an ultra-slim 9-millimeter diameter probe and the SEEKER 400-05 system is
supplied with an superslim 5.5-millimeter diameter probe. Whichever SEEKER
400 system you’re using the other probes are available options and are in-
terchangeable with the base unit. Note that the camera head and probe cable
are waterproof, as are the extensions, which, if firmly connected, will make the
entire probe waterproof.
To remove the supplied probe from the handle (
Fig.8
), turn the collar that con-
nects them in the direction shown on its surface — counterclockwise — and
pull the probe straight out from the
handle. To re-attach the probe, or
attach the extensions, reverse the
process, making sure that the
“alignment key” at the end of each
probe lines up with the flat on its
coupling. Tighten the connections
by turning the collar clockwise.
MONITOR
The other main component of the Seeker 400 system is its
3.5-inch color LCD monitor (
Fig.9
). Because the monitor can
communicate wirelessly with the base unit, it can
show what the probe sees even when the two units
are located as far apart as 10 meters, or 32 feet.
When the monitor is attached to the pistol-grip han-
dle, the two units communicate via hard-wired con-
nections, rather than wirelessly. This improves the
quality of the still images and video captured by the
system.
13
Keyed Ends
Fig.8
Fig.9
