General FCS18, Operator'S Manual

Page: 15 / 29

FCS18 RIP-R-STRIPPER FLOOR COVERING STRIPPER
FORM GOM19061901US, VERSION 1.0
English-EN
14
FIGURE 24
NOTE:
Motor will not restart if power is lost then comes back on. If this occurs,
repeat starting sequence STEPS 14 through 16.
17. Set forward motion speed control to desired speed. FIGURE 25
FIGURE 25
18. Using proper operator stance, push with both thumbs on forward/reverse
paddle control to begin floor covering removal process.
FIGURES 26 & 27
FIGURE 26
FIGURE 27
19. As job progresses refer to FLOOR COVERING REMOVAL
TECHNIQUES in APPLICATION THEORY & TECHNIQUE section of this
manual for more information.
20. Consistently remove loose flooring material to determine proper material
removal depths and extent of work completed. Lack of proper dust
collection system and/or broom use can increase problem.
IMPORTANT: Properly dispose of all accumulated floor covering materials
according to international and local environmental regulations.
RIP-R-STRIPPER normal use creates material build-up on machine. It is highly
recommended all exposed internal/external surfaces be properly cleaned after
each use plus, adjust wheel scraper clearance to minimize build-up on wheels.
Refer to MAINTENANCE INSTRUCTIONS section of this manual for more
information.
STOPPING RIP-R-STRIPPER
21. In emergency situations only, such as an extension cord becoming
entangled about RIP-R-STRIPPER and/or operator, firmly hit emergency
stop button. Entire unit will shut off when activated. FIGURE 28
WARNING
•
Properly dispose of all accumulated floor covering
materials per OSHA and EPA codes/regulations.
•
Many materials can be classified as hazardous requiring
proper disposal procedures.
•
Contact applicable government agencies for specific
information.
DANGER
•
DO NOT modify, bypass or disable RIP-R-STRIPPER
emergency stop button, main power and/or blade ON/OFF
switches.
•
DO NOT operate machine if emergency stop button, main
power and/or blade ON/OFF switch is not functioning
properly.
•
Such configuration will not allow operator to quickly stop
RIP-R-STRIPPER in event of an emergency, prevent
unexpected machine start-up, loss of control and/or
“runaway” machine and can result in property damage
and/or personal injury.
DANGER
•
Always maintain proper control of RIP-R-STRIPPER.
•
Exciter plate begins movement when motor starts. There
is no automatic motor shut off feature on machine.
•
If operator loses control, a “runaway” machine can result
in property damage and/or personal injury.