2.
Place the supplied L-jig, as shown at far right
A
, on
top of the table. Adjust the rail height until the bot-
tom of the jig is flush with the rail shelf. Hold the nuts
firm with a 7/16" wrench and tighten the two screws
on left and right ends of the rail. Tighten the center
screws only after double-checking rail height using
the L-jig all along the rail and at both ends.
FRONT FENCE RAIL
1.
Install the T-50 front guide rail on the front of the saw aligning the holes in the rail with those on the the saw as
shown below.
INSTALL THE T-FENCE ASSEMBLY
Please note that there are detailed installation and operating instructions in the F-42 manual supplied in the box with the
F42 rip fence.
3.
Assemble the guide tube
B
to the front fence rail
by fastening the 7 hex head bolts (3/8” x 3/4”)
C
to
the underside of the rail.
Note: When the tube is attached, there will be a gap of
about 1” between it and the rail D in which part of the
fence will ride.
Note: If you have purchased either Deluxe 50-300CE or
50-305CE Chrome edition, please skip ahead to the
“Install the table extension, dust tube and hoses” installa-
tion instructions on page 13 before assembling the guide
tube to the front fence rail.
REAR FENCE RAIL
1.
Install the T-50 rear guide rail on the rear of the saw aligning the holes in the rail with those on the saw as shown
below.
A
12
D
C
B
Summary of Contents for 50-300
Page 34: ...34 BLADE GUARD ASSEMBLY Model 50 300CE 305CE only where specified ...
Page 37: ...WIRING DIAGRAM 37 ...
Page 38: ...WIRING DIAGRAM 38 ...
Page 39: ...WIRING DIAGRAM 39 ...
