25
MAKE SURE THE MACHINE HAS BEEN TURNED OFF AND UNPLUGGED FROM THE POWER SOURCE BEFORE PERFORM-
ING ANY MAINTENANCE OR ADJUSTMENTS.
CLEANING ANTI-KICKBACK FINGERS
The anti-kickback fingers on this planer are designed
to reduce the risk of injury due to kick-back by prevent-
ing the workpiece from being violently ejected from the
machine.
In order for the anti-kickback fingers to move freely and
operate correctly, you must clean off any dust, particles
or residue left behind.
A
ALIGNING THE BELTS
1.
Remove the left panels using a 4 mm Allen key
B
.
2.
Using a straight edge
C
, verify that the pulleys are
properly aligned.
To align the pulleys, proceed as follows:
3.
Open the motor access door.
4.
Loosen the two nuts
D
and the four nuts
E
using 24
mm & 14 mm wrenches, then slide the motor on its
mounting plate so that the pulleys are aligned.
5.
Retighten the four nuts
E
and the belt tension nuts
D
.
Note: check tension by pushing the belt with your finger. The
belt should not move more than 1/2”.
6
. Close the motor access door and re-install the pan-
els before starting the machine.
C
B
E
E
D
