MAKE SURE THE MACHINE HAS BEEN TURNED OFF AND UNPLUGGED FROM THE POWER SOURCE BEFORE PERFORM-
ING ANY MAINTENANCE OR ADJUSTMENTS.
ADJUSTING THE INFEED & OUTFEED ROLLERS
1.
Begin by take note of all the components in order
to make required adjustments:
A
infeed roller;
B
chipbreaker;
C
cutter head with knife/insert;
D
out-
feedroller.
2.
Place the gauge block
E
under the knife/insert
C
,
adjust the table height until you can only slide a
0.02” feeler gauge
F
between the block and the
cutter. Once finished, do not move the height of the
table.
A
B
C
D
E
0.0
2”
F
ADJUSTING THE CHIPBREAKER
3.
Place the block
E
under the end of the infeed roller
A
as shown. Loosen the nut
G
, turn the screw
H
until
the roller touches the top of the block, and then re-
tighten the nut
G
. Repeat for the other end.
4.
Place the block
E
under the end of the outfeed
roller
D
. Loosen the nut
I
, turn the screw
J
until the
roller touches the top of the block, and then re-
tighten the nut
I
. Repeat for the other end.
E
E
G
H
I
J
1.
Place the block
E
under a knive/insertion and ad-
just the table height until you can slide only a 0,004”
feeler gauge
K
between the block
E
and the knive/
insertion. Then place the block under the chip-
breaker
B
.
E
0.0
04”
K
2.
Remove the dust chute, remove the two bolts
L
with
a 10 mm wrench, and then lift the chip deflector
cover in order to access the cutter head.
L
L
LEFT SIDE
RIGHT SIDE
REAR VIEW
REAR VIEW
17
