3.
Attach the 2 vertical support rods
F
to the base
using (4) hex flange head bolts
G
, as shown in
H
.
NOTE: The front and rear support rods are identical. They are
rectangular and have flat ends to sit flush to the base.
4.
Attach the 3rd support rod
I
as shown in
J
, using 2
hex flange head bolts.
NOTE: The 3rd rod
I
has an angled end to sit over the lip of
the base.
F
G
H
I
J
5.
With the help of an assistant line up the holes in the
impeller/separator assembly with the holes in the
support rods, and attach the assembly to the rods
using hex flange head bolts.
6.
Attach the handle to the impeller assembly as
shown using 2 hex head bolts
K
to secure it in
place.
7.
Peel off the backing of the narrow adhesive foam
gasket and stick it around the lower end of the
drum
L
, making sure the gasket is sitting in the
groove,
M
.
8.
Repeat with the wide foam gasket around the
upper end of the drum,
N
.
K
L
M
N
10
8.
Fit the canister filter onto the drum and use the
bigger belt clamp to secure the canister to the
drum as shown in
O
.
P
O
USE CAUTION AND WEAR GLOVES WHEN HANDLING ME-
TAL PARTS SUCH AS BELT CLAMPS, WHICH CAN CUT IF
HANDLED CARELESSLY.
Tip/Hint: To seat the canister on the rim of the drum, run
a flat piece of wood (such as a ruler) between the drum
and the black apron on the bottom of the canister,
P
.
