SETUP INSTRUCTIONS
INSTALL BATTERIES
1. The meter’s battery compartment (Fig. 1,
Callout F) is accessible from the bottom
of the unit. Slide the battery compartment
cover down and away from the EP8711P
and set it aside.
2. Insert the three supplied “AAA” batteries
in the compartment, orienting them as
shown on the diagram stenciled on the
battery compartment cover
3. Replace the battery compartment cover
and slide it up until it latches shut.
OPERATING
INSTRUCTIONS
Before making any measurements, rotate
the sensor protection cap (Fig. 1, Callout A)
with your thumb and index finger so both of
its vents are open to the ambient
environment. Press the
MODE
button to
power on the meter. The LCD will
immediately begin reading out the RH value
of the environment. The reading will be
accompanied by the term
RH
in the upper
left corner of the LCD.
To display the ambient temperature
, press
the
MODE
button once.
TEMP
will replace
RH
on the top line of the LCD.
8