NAME AND FUNCTIONS OF BUTTONS:
Press Functions
Hold 3 seconds
CH
Select Channel 1,2,3
Delete current channel
SET
Zone Time/Home Time
Enter clk & cal setting
AL
Read Alarm time 5 sec
Alarm set setting
MEM
Read maximum/ minimum temperatures, humidity
+
1 step forward
Fast advance
Alarm on/off
-
1 step backward
Fast backward
°C/°F
R/C On/Off
Zz
Trigger snooze alarm & extended backlight
BARO
Nil
Enter altitude
왖
Select hPa/inHg altitude
Adjust altitude level
왔
Step backward for altitude
Adjust altitude level
BATTERY INSTALLATION
HOME RECEIVER:
Lift off the battery cover at the back, install 2 “AA” batteries according to the polarity
indicated, close the battery cover.
REMOTE SENSOR:
Lift off the bracket stand, loosen the 4 screws with a small screwdriver, insert 2
“AAA” batteries according to the polarity indicated. Replace the cover and tighten
the 4 screws.
SETTING UP THE WIRELESS THERMOMETER:
• For the first installation, always insert batteries to the home unit and then the
remote sensor. Set Channel 1 for the first remote sensor. Set channel 2 and
channel 3 for the 2nd and 3rd sensor.
• Press the Tx button on the back of remote sensor to verify the RF reception.
• If more than 1 sensor is connected, press “CH” to select Ch1, Ch2, Ch3.
°C/°F SELECTION, TIME
Press “ – ” to select ºC/ºF
MOON PHASE
Moon phase will be displayed automatically according to current calendar.
SETTING UP THE BAROMETER
When power up, the air pressure (based on your current altitude level) will be
displayed.
To offset the reading to sea level pressure, hold “BARO” button for 3 seconds.
“0” meter will flash, set the approximate altitude of your existing location using
“
왖
” and “
왔
”. For example, you may enter 100 meters if you are living in a building
DBAR880 MANUAL-FINAL-91307 9/13/07 4:28 PM Page 2
