Speedrooter 92R
®
6
INSTALLING THE GUIDE TUBE HOLDER
1. To install the Guide Tube Holder on The Metro, follow the as-
sembly shown in the diagram below. Place the Guide Tube Hold-
er on the mounting knob, then thread it onto the bolt to secure
the Power Cable Feed. (See diagram below.)
2. To secure the end of the Guide Tube, place it between the frame
support tubes.
3. Bend the Guide Tube back into the Holder so that it catches a
coil near the end of the Guide Tube. (See photo below.)
THE CABLE AND SPRING ARE UNDER TENSION
WHEN ATTACHED TO THE HOLDER.
USE CAUTION WHEN RELEASING THE GUIDE
TUBE FROM THE HOLDER.
1. Place machine at a distance not
greater than two feet (.6m) from the
drain opening. Be sure the Speed-
rooter Guide Tube (S92-GT) is in
place. If you can't get the machine
this close to the drain opening, run
the cable through the optional Guide
Tube Extension (GTE) or a metal
guide tube to prevent cable whip-
ping.
2. Position the air foot pedal for easy accessibility. The machine is
designed for one-person operation. Be sure you can quickly re-
move your foot from the pedal in an emergency.
3. Be sure the motor switch is in the
off
position.
4. Make sure the Power Cable Feed is set to match the cable size
you have selected. If you’re using 3/4" or 5/8” cables, the feed
should be assembled with the raised side of the lower two caps
outward.
5. Select the proper cutting tool (See Cutter Application Chart
—
Table 2). A good tool to start with is the Spearhead or 2” U
-
Cutter. If you are having difficulty getting around a P-Trap or
close bend, try the flexible leader. After the line has been
opened, follow with larger blades, which scrape the inside edges
of the pipe, assuring a real cleaning job.
6. Insert the cutter into the female connector at the end of the cable
and tighten the connecting screw and lock washer
firmly
in
place.
OPERATION
SET-UP
MAKE SURE THE MOTOR SWITCH IS IN
THE ‘OFF’ POSITION!
