Power-Vee
®
TROUBLE SHOOTING GUIDE (TABLE 3)
Problem
Probable Cause
Solution
Cable kinks or breaks.
Operator forcing the cable.
Do not force the cable. Let the cutter do the work.
Too much slack between machine and drain.
Do not allow more than six inches between machine and drain.
Cable used in wrong size drain line.
A cable that is too large or too small in diameter for a line is more
likely to kink. (Consult Table 1
—
Cable Applications.)
Cable exposed to acid
Clean and oil cables regularly.
Cable tangles in container. Operator forcing the cable.
Do not force the cable. Let the cutter do the work.
Failure to feed.
Feed Rollers frozen.
Clean and lubricate feed rollers regularly. Replace worn rollers.
Cable tangled in drum.
Use proper cable size. (Consult Cable Application Chart
—
Table 1).
Motor does not run.
Trigger in neutral (off) position.
Switch Trigger to either Forward or Reverse.
Motor turns in one direction
but not other.
Reverse switch failure.
Replace reverse switch.
7
See pages 23 and 24 for Parts List and Schematic Diagram.
Summary of Contents for Power-Vee
Page 8: ...Power Vee 8 ...
