General Music rp-x, Owner'S Manual

Page: 15 / 100

Page 9
owners manual
rp-x
r p -x
r p -x
r p -x
r p -x
r p -x
r p -x
r p -x
r p -x
EFX - EFX +
SELECTING THE PARAMETERS TO EDIT IN THE SELECTED PARTS (CH): VELOCITY
Press the EDIT button to select the VELOCITY param-
eter. The display indicates the current default value,
in this example.
Velocity - Ve
NOTE
SELECTING THE PARAMETERS TO EDIT IN THE SELECTED PARTS (CH): TRANSPOSE
SELECTING THE PARAMETERS TO EDIT IN THE SELECTED PARTS (CH): TUNE
NOTE
Transpose - Tra
Tune -
Tune +
SELECTING THE PARAMETERS TO EDIT IN THE SELECTED PARTS (CH): EFX
This parameter allows you to set a programmable VELOCITY offset , in order to increase or decrease the
velocity value of incoming MIDI notes transmitted by a MIDI controller. Value range: -64/00/+63. Value=00
does not affects the original velocity values.
If you need it, You can set the VELOCITY value, by
pressing the DATA buttons. The display show you
in realtime the value changing.
The parameter VELOCITY it's GLOBAL, then its setting will affect ALL the parts at the same time. For this reason it can be
selected if the "
ALL " mode has been enabled only. About the "ALL" mode please consult pages #7 and #10 .
It is possible to restore the VELOCITY, TRANSPOSE and TUNE default value , by pressing the two DATA buttons at the same time.
TRANSPOSE allows to shift the PART (CH) pitch in a range of +/- 24 semitones.
Press the EDIT button to select TRANSPOSE. The dis-
play indicates the current default value
(TRANSPOSE=00, C=C), in this example.
Pressing the DATA buttons to increase or de-
crease the PART transpose. The display show you in
realtime the value changing. Each single step (+/- 24)
correspond to a semitone.
TUNE allows you to shift the PART (CH) pitch fine tuning in a range of : - 64/00/+ 63.
Press the EDIT button to select TUNE. The display
indicates the current default value (TUNE= 00), in
this example.
Pressing the DATA buttons to increase or de-
crease the PART TUNE. The display show you in
realtime the value changing.
Set the EFX send level (chorus, tremolo, phaser, delay etc.) in the selected PART.
Press the EDIT button to select the EFX. The display
indicates the current default value (EFX = 000), in
this example.
Pressing the DATA buttons to increase or de-
crease the EFX send in the selected part. The display
shows you in realtime the value changing. The pa-
rameter range is from 0 to 127.