General International BT8005, Setup And Operation Manual

Page: 6 / 28

ENGLISH
6
HEALTH NOTICE: Some dust created by power sanding, sawing,
grinding, drilling, and other construction activities contain chemicals
known to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
─Lead from lead-based paints
─Crystalline silica from bricks and cement and other masonry products
─Arsenic and chromium from chemically-treated lumber
Your risk from these exposures varies, depending on how often you do
this type of work. To reduce your exposure to these chemicals, work in
a well ventilated area, and work with approved safety equipment, such
as those dust masks that are specially designed to filter out microscopic
particles.
GETTING STARTED
Before operating your BT8005 14-Inch Cut-Off Saw, check the contents of
the box to make sure you have everything you will need.
Items included in the box:
● 1 BT8005 Cut-Off Saw
● 1 Saw Blade
● 1 Wrench
● 1 Set up and Operation Manual
POWER SOURCE CONNECTION
POWER REQUIREMENTS
This tool is designed to operate on a properly grounded 120 volt, 60 Hz,
single phase alternating current (AC) power source fused with a 15 amp
time delayed circuit breaker. It is recommended that a qualified electrician
verify the ACTUAL VOLTAGE at the receptacle into which the tool will be
plugged and confirm that the receptacle is properly grounded. The use of
the proper circuit size can eliminate nuisance circuit breaker tripping when
using your tool.
CAUTION: DO NOT OPERATE THIS TOOL if the ACTUAL power
source voltage is less than 105 volts AC or greater than 132 volts
AC. Contact a qualified technician if this problem exists. Improper
performance, and/or, damage to the tool will result if operated on
inadequate, or excessive power.
CONNECT TO POWER SOURCE
Consult a qualified electrician for proper installation of receptacle at the
source of power. This tool must be grounded while in use to protect the
operator from electrical shock. If you are not sure if your outlet is properly
grounded, have it checked by a qualified electrician. Make sure the tool is
turned OFF when connecting the power cord to a properly grounded 120
Volts, 60 Hz, single phase, 15 amp power source.
!