General International BS5105, Setup And Operation Manual

Page: 8 / 32

ENGLISH
8
UNPACKING
REMOVE ALL THE PARTS FROM THE BOX
WARNING!
If any part is missing or damaged, do not plug in your tool
until the missing or damaged part is replaced.
Your saw is fully assembled in the carton with the exception of the table,
the hardware to fasten it, the table insert, rip fence, and miter gauge.
ASSEMBLY AND SETUP
WARNING!
To reduce the risk of injury, never connect plug to power
source outlet until all assembly steps are complete and until you have
read and understood the entire owner’s manual.
TABLE
INSTALLATION
1. Loosen the upper blade guide locking knob (N, fig1 & 2) and rotate the
upper blade guide adjustment knob (O, fig 1 & 2), which will raise the
upper blade guide (Q, fig 1 & 2) to the highest position.
2. Place the table on the table support by sliding the slot in the table over
the blade. Be careful not to damage the blade.
3. Align the four holes on the bottom of the table over the four holes in the
table support. Fig 4 looks at the table from below.
4. Place a washer and locking washer on each bolt and secure the bolt
through the table support (dd, fig 4) and into the table (F, fig 4).
5. Tighten all four bolts to make sure the table is fastened securely.
6.
Align the slit in the plastic table insert (V, fig 3) with the slit in the table
and the blade.
7. Press the inset into the square opening in the middle of the table.
ADJUSTING TILT
1. Loosen the upper blade guide locking knob (N, fig1 & 2) and rotate the
upper blade guide adjustment knob (O, fig 1 & 2), which will raise the
upper blade guide (Q, fig 1 & 2) to the highest position.
2. Set the table to zero degrees and lock it there. Place a small
combination square on the saw table beside the blade and check
squareness of the saw table to the blade.
3. If an adjustment is needed:
● Loosen table tilt adjustment lock knob.
fig 3
G
U
V
F
!
!
fig 4
F
dd
ee