English
12
4. add lockwashers and hex nuts (not included) and tighten.
CAUTION!
To avoid injury from tool movement, the supporting surface
where the belt / disc sander is mounted should be watched carefully after
mounting to ensure that no movement will take place during use. If any
tipping or walking is noted, secure the workbench or the supporting
surface before operating the belt / disc sander.
CLAMPINg THE SANDER TO THE WORkBENCH
a third alternative is that the belt / disc sander can be clamped directly to
a workbench using two or more c-clamps on the base of the unit (at least
one clamp on each end- fig.6).
INSTALLINg SANDINg DISC AND gUARD
1.
Locate the peel-and-stick sandpaper disc (V, fig.7
) and remove the
backing from it.
2.
Align the edges of the disc with the sanding plate (W, fig.7) and press
the disc firmly into position all the way around.
3.
Locate the disc guard (U, fig.7) and, from the loose parts bag, two
Phillips pan head type AB M4.2 x 1.4-12 screws (a, fig.7).
4. Position the disc guard against the lower third of the disc, aligning the
holes as shown.
5. using a Phillips screwdriver, fasten the disc guard to the sander with the
two screws, applying slight pressure to thread the holes.
Sander base / Base de ponceuse
2-21/32
in. / po
67.5 mm
3/4
in. / po
19 mm
13-7/16 in. / po
9/16
in. / po
14.3 mm
2 holes / 2 trous
diam : 3/8 in. / 3/8 po
24 in. / 24 po (61 cm) minimum
18 in. / 18 po (46 mm) minimum
fig 5
Summary of Contents for BD7004
Page 23: ...English 23 150311 Schematic Drawing...
Page 24: ...English 24...
Page 47: ...FRan ais 47 150311 Schema...
Page 48: ...Fran ais 48...
