INSTALL THE BANDSAW ONTO THE BASE CABINET
The bandsaw mounts onto a base cabinet which provides
storage space for the miter gauge and replacement-
blades.
Important! Make sure all stand fasteners are firmly tightened
and that the stand cabinet is installed on a solid, flat and sta-
ble floor that is able to support the weight of the bandsaw 191
LBS (87 kg)
The bandsaw is heavy. Do not over-exert. The help of
an assistant will be needed for the following step.
Do not grip the bandsaw by the lower wheel cover
door when lifting. Keep hands away from blade at all
times.
1.
Position the bandsaw over the four holes on top of the
base cabinet.
2.
Using a 13 mm open end wrench and a 13 mm so-
cket wrench, secure the bandsaw to the stand as
shown using the 4 hex head bolts
A
, 8 flat washers
B
and 4 hex nuts
C
.
Note: The hex nuts must be tightened from inside the cabinet.
A
B
C
The dust port
A
has a 2 –1/2" opening to accommodate
connection to a dust collector (not included). Install the
dust outlet on the right side of the bandsaw as follows:
1.
Open the lower wheel cover door.
2.
Using a 10 mm wrench, attach the dust port to the
edge of the door as shown using the hex bolts and
washers
B
already attached to the dust port.
ATTACHING THE DUST PORT
ATTACHING THE TABLE-TILT BRACKET
The work table mounts on a bracket which allows adjust-
ment from flat (0°) to any angle up to 45° to the right.
Adjustments can be made easily with the angle scale and
lock knobs.
1.
Remove the two hex bolts and washers from the lower
wheel housing
A
.
2.
Place the table-tilt bracket
B
on the lower wheel hous-
ing as shown in
C
and align holes to the threaded
holes in the lower wheel housing (hole
D
is not used).
3.
Place washers on the two hex bolts
E
and
F
and in-
sert the bolts through the table-tilt bracket holes and
into the threaded holes in the lower wheel housing.
4.
Tighten
loosely
, using a 12 mm open end wrench
and 12 mm socket wrench.
5.
Thread a nut onto the longer table-stop bolt
D
and
screw the bolt into the hole on the rear tab of the table
tilt bracket.
* Final tightening will be done after centering the table
opening with the blade.
LOWER WHEEL HOUSING
A
NOT USED
B
C
D
E
F
E
F
D
11
A
B