ASSEMBLY INSTRUCTIONS
SERIOUS PERSONAL INJURY COULD OCCUR IF YOU CONNECT THE MACHINE TO THE POWER SOURCE BEFORE YOU
HAVE COMPLETED THE INSTALLATION AND ASSEMBLY STEPS. DO NOT CONNECT THE MACHINE TO THE POWER
SOURCE UNTIL INSTRUCTED TO DO SO.
1.
Thread a leveling foot
A
with a hex nut
B
on both
side panels as shown above.
2.
Attach the left and right side panels to the tool tray
using 8 carriage bolts
C
and flange nuts
D
, then
tighten using a 12 mm open wrench.
3.
Attach the top plate to the left and right side pan-
els using 4 carriage bolts
C
and flange nuts
D
as
shown above.
Note: The flanges of the top plate should fit inside the cabi-
net
E
.
4.
Attach the rear panel to the top plate and tool tray
using 4 Phillips head screws
F
as shown above.
ASSEMBLE THE BASE CABINET
D
C
F
E
H
G
5.
Attach the door knob
G
to the door using the sup-
plied hex head bolt
H
and lock washer
I
as shown
above.
I
10
A
B
6.
Attach the door to the hinges on the right side pa-
nel as shown using 4 Phillips head screws
J
.
Note: Hinges go behind side panel edge
K
.
J
K
